SIMPLY HELP! Version 1.06  April 1992



    The Simply Help! package consists of two self-extracting archive files
    created with Lharc version 2.12.  Both of these are needed and should
    be unpacked into one directory, if you have a hard drive.  If you are
    using floppies unpack each file (SHLP1.EXE, SHLP2.EXE) onto separate
    floppies.  This can be done by running the INSTALL.EXE program or
    manually with the commands listed below.  It is assumed that the
    distribution disk is in drive A.


    HARD DISK        ;Enter the following DOS commands
    ---------
                     C:              (Or drive of your choice)
                     MD\SHLP         (Or directory of your choice)
                     CD\SHLP
                     A:SHLP1
                     A:SHLP2


    FLOPPY DISK      NOTE: You must have two floppy drives and two formatted
    -----------            360K disks or one 720/1.2M/1.44M disk

                     ;Insert blank disk in drive B and label it 'Disk# 1'
                     ;Enter the following DOS commands

                     B:
                     A:SHLP2 

                     ;Insert second blank floppy in drive B: if using
                     ;360K disks and label it 'Disk#2'

                     A:SHLP1


    
    The complete manual for this package is in the file called SHDOCS.EXE.
    This allows you to view the manual on the screen or print it either to
    your printer or a text file.  You can also install the manual as a TSR
    so you can read the manual as you try the program.  Just select Install
    TSR from the menu to do this.  It can be removed later with the same
    menu choice.

    You should ignore the section in the manual on installing the program, 
    as it assumes the program comes on two floppies rather than compressed
    on one.

    Start the editor by typing "SHED".  There are a couple of source files
    included that you can play around with when using the editor.  The
    online help for the editor contains almost as much information as the
    manual so go ahead and try it out.  If you are unsure about anything
    just press F1 for help at any time.  You can read the manual later.

    BASIC programmers should load the SHELP.SRC into the editor and run it
    for the latest information on the libraries included with Simply Help!

    See the file "PACKING.LST" for a complete list of files and what they do.
    Thanks for trying Simply Help!


           (LHArc version 2.12  Copyright (c) Haruyasu Yoshizaki)