@echo off

:: To use this batch file, type the INPUT file name as the first
:: parameter, and next the name of the OUTPUT file. Note 
:: that the batch file supplies the "-W" parameter automatically. If 
:: you are using the UNregistered version of WordSmart, the "-Q" 
:: switch used in the command line below will not have any effect. 
:: (See the documentation for more information about the WordSmart 
:: commands that are supported in the registered version.)

if "%1" == "" goto NOPARM

WSM %1 -w %2 -q   %3 %4 %5 %6 %7 %8 %9

echo.

if errorlevel 5 goto read_only
if errorlevel 4 goto targeterr
if errorlevel 3 goto exist  
if errorlevel 2 goto cantoverwrite
if errorlevel 1 goto readerr

echo.
echo ---------- WordSmart: Processing was successful ---------- 
goto end
:read_only
echo.
echo ---------- WordSmart: The output file (%2) is Read only! ---------- 
goto end
:targeterr 
echo.
echo ---------- WordSmart: Can't write the output file (%2)! ---------- 
goto end

:cantoverwrite
echo.
echo ---------- WordSmart: Cannot overwrite itself! ---------- 
goto end

:exist
echo.
echo ---------- WordSmart: Output file exists! (use '-O' to over-write) ---------- 
goto end

:readerr
echo.
echo ---------- WordSmart: Can't find specified input file (%1)! ---------- 
goto end

:noparm
echo.
echo This batch file requires some parameters on the command line.
echo Read the text at the start of the batch file itself for
echo more information.
echo.
pause
cls
WSM

:end