************************************************************************
  *                                                                      *
  *                     Paper Route Ledger - Version 1.3                 *
  *               Copyright (c) 1994  by BlueCollar Software             *
  *                                                                      *
  *                       Published exclusively by:                      *
  *                         RMH Computer Services                        *
  *                              PO Box  657                             *
  *                       Beech Grove IN 46107-0657                      *
  *                            (317)  782-9903                           *
  *                                                                      *
  ************************************************************************

Paper Route Ledger (PRL) is provided with an installation utility, which 
will not only install the program for you, but will also test your system 
for the necessary free hard drive space and minimum DOS version. It will 
also check your CONFIG.SYS file for necessary parameters, and will even 
update those settings for you if necessary (you can also choose not to let 
it do this if you wish). It will also add the PRL subdirectory to your 
system PATH statement if you want.

If PRL was down loaded from a computer bulletin board or other electronic 
service, it will most likely be compressed and placed in a .ZIP, .ARC, or 
similar file. Place the compressed file in a temporary subdirectory on your 
hard disk drive, other than the root directory.  Decompress the downloaded 
file using the appropriate procedures for your system. Then, simply change 
to the temporary subdirectory, type INSTALL, and press [ENTER]. 

   (On some machines the [ENTER] key may also be labeled [RETURN])

If you are installing PRL from a distribution diskette, simply place the 
installation diskette in an available floppy disk drive, which will usually 
be either "A" or "B". Then, from any DOS prompt, type A:INSTALL (or 
B:INSTALL, as appropriate), and press [ENTER].

You will be presented with a menu showing 3 different installation 
sources (1 floppy disk, 2 floppy disks, or install from hard drive). Select 
the appropriate installation source by using the up/down arrow keys to 
highlight the proper selection, and press [ENTER].

This program must be installed in a hard disk drive, and there must be at 
least 2Mb of free disk space available.