A Logic Probe for the beginner.
                       -------------------------------


    Minimum operating requirements are:-
    ------------------------------------

    1) Standard Amiga A500 with 512Kb or more of memory.
    2) Workbench 1.3x.
    3) An external floppy disk drive is required.
    4) OCS.
    5) The mouse is optional.
    6) The software has NOT been tested on an Amiga A1000.
    7) The software has NOT been tested on Workbench 1.2x or less.
    8) The software has NOT been tested on Workbench 3.1x or greater.

----------------------------------------------------------------------------

    General information:-
    ---------------------

    This tool will show a Logic ~0~, Logic ~1~, Indeterminate DC State or
    Indeterminate Pulse Train.

    This software was written using ACE basic compiler.

----------------------------------------------------------------------------

    Now the legal stuff:-
    ---------------------

    This program is the copyright of (C)2000 Barry Walker with all
    rights reserved.
    It is freeware and no profit will be made from it, also the files
    must remain unaltered.
    The author is not responsible for any damage to, or loss of, or
    failure of equipment or data caused in any way by the use of this
    program.

----------------------------------------------------------------------------

    Testing evaluation:-
    --------------------

    This was tested on an A500 with various memory configurations,
    the same A500 switched to 1MB Chip Ram and emulating WB2 using
    the A500+ emulator, an A600 with various memory configurations,
    the same A600 emulating WB3 with various memory configurations,
    an A1200 with various memory configurations, and a similar A1200
    with a Turbo LC accelerator board and an '030 with 34MB of ram
    thanks to Laurence J Greatorex, and also to Bob Eva with his
    A1200 setup, with a total of 10MB of memory.

----------------------------------------------------------------------------

    Next major project:-
    --------------------

    The next project will be an Absorption RF Wattmeter. It will measure
    up to 10 Watts RF power output into a 50 Ohm dummy load. Frequency
    Range from 1 Mhz to approximately 500 Mhz.

----------------------------------------------------------------------------

    Bug Reports:-
    -------------
    All bug reports should be sent in plain text to my Compuserve Email
    address i.e.     106161.3245@compuserve.com     and I will endeavour
    to cure them.


    Contact:-
    ---------

    Mr Barry Walker,
    70 King George Road,
    Loughborough,
    Leicestershire,
    LE11 2PA,
    England.

    Email to:-

    106161.3245@compuserve.com
    or
    wisecracker@tesco.net

    BYE.....

----------------------------------------------------------------------------