Short:    GadTools audio mixer for Prelude
Uploader: Thomas Wenzel (wenzel@act-net.com)
Author:   Thomas Wenzel (wenzel@act-net.com)
Type:     util/cdity
Version:  2.0


Minimum requirements
--------------------
prelude.library 2.41
AmigaOS 3.0

Introduction
------------
Prelude Mixer is a commodity that lets you control, save and restore the
settings of Prelude's onboard audio mixer.

It should be quite obvious how it works, so I'll only explain the tricky
parts :-)

Tips
----

The tooltype INIT determines if the mixer will soft reset the Prelude upon
startup. Normally you should set it to INIT=yes.

If no config file (or an old, incompatible one) is found in ENVARC, a
requester will pop up and you have to adjust all settings (again) and
save them using the menu Project->Save or by pressing Amiga-S.

Edit->RESET CARD resets the Prelude and should only be executed if a
serious problem occured so that normal record or playback operation isn't
possible any more.

Edit->SMALL IRQ is new. When selected, less data will be transferred from
and to the Prelude during each interrupt, causing more but shorter
interrupts. This settings should solve the problem with data loss on
serial interfaces without FIFOs. Changing this setting will automatically
cause a soft RESET. Be sure that no other program is using the Prelude
when you change it!

You can use the tooltypes LINETEXT, AUX1TEXT, etc. to configure the labels
above each slider. The maximum text length for each label is 9 characters.

Legal stuff
-----------
Prelude Mixer is part of the Prelude distribution, all rights reserved.